Archive
12.11.2026
I/O modules
Spark protection barrier
Recorders and archivers
Meters and converters of electrical network parameters
Counters, timers, tachometers
Liquid level indicators and regulators
Programmed logical controllers
Manual signal transmitters
Technological signaling devices
Power supplies
Codesys PLC controllers
Normalizing converters
Galvanic isolation and branching blocks
Communication interface converters and amplifiers
Analytical instruments
Switching blocks
Control and protection units
GSM communication routers / modems
Archive
12.11.2026
Author
Based on an article by Yaroslav Yakymovych in ElektroTEMA newspaper, 2009
In early February 2009, Promenerhiia, a company from Buchach in Ukraine's Ternopil region, put the restored Sulori small hydropower plant in Georgia into operation. The plant's automation system is built with controllers and instruments made by Microl LLC.

The Sulori plant had been operating since the 1960s, and over the decades its equipment had become worn out and obsolete. The Georgian side, led by Professor Nodar Ugrelidze of Tbilisi Technical University, decided to restore the plant and brought in specialists from the Ternopil region — Promenerhiia (director Oleh Khomytskyi, technical director Petro Lytkovets).
Promenerhiia carried out the most knowledge-intensive part of the work:
The company developed and implemented a plant monitoring and control system based on the Softlogic S3 SCADA (Real-Time Systems JSC, Dnipropetrovsk). Process monitoring and visualization use MIK-51 controllers and MTR-8 and MTL-32 instruments made by Microl LLC (Ivano-Frankivsk).
The system automatically starts and stops the hydro units, performs emergency shutdown of the plant, and monitors and controls more than 170 parameters, including:

Mimic diagram of the Sulori plant in the SCADA system
The guide vanes of the Francis turbine are driven by a DC electromechanical actuator (AC on customer request), which adjusts output according to water flow. Compared with a high-pressure hydraulic system, this electric drive is more reliable, simpler to operate, positions more accurately and is more environmentally friendly.

Hydro turbine of the Sulori plant
According to Oleh Khomytskyi, almost all the equipment for the mini hydropower plant in Georgia came from Ukrainian manufacturers: microprocessor controllers, regulators and modules from Microl (Ivano-Frankivsk), turbines from Minihidro of Kharkiv, and generators from the ZKEM plant in Nova Kakhovka. The director of Promenerhiia is convinced that Ukrainian products are as good as their foreign counterparts while costing much less, so choosing domestic manufacturers supports them and helps them grow.
Going forward, the company planned to focus on wind power. In Oleh Khomytskyi's view, there is plenty of work in building and automating small hydropower plants across many regions of Ukraine — and beyond.
For more information about the products mentioned in this article, please contact Microl LLC:
+38 (0342) 502-701
+38 (067) 359-70-90
+38 (095) 092-07-28
sale@microl.ua, microl_zbut@microl.ua, zbutmicrol@gmail.com
www.microl.ua
Technical support:
+38 (0342) 502-702
+38 (067) 704-00-29
+38 (095) 302-37-57
support@microl.ua, supmicrol@gmail.com
Prepared on the basis of the article by Yaroslav Yakymovych "Promenerhiia of Buchach in the 'Georgian project'", all-Ukrainian industry newspaper ElektroTEMA, 2009.
Open the booklet / download PDF