Archive
18.11.2026
I/O modules
Spark protection barrier
Recorders and archivers
Meters and converters of electrical network parameters
Counters, timers, tachometers
Liquid level indicators and regulators
Programmed logical controllers
Manual signal transmitters
Technological signaling devices
Power supplies
Codesys PLC controllers
Normalizing converters
Galvanic isolation and branching blocks
Communication interface converters and amplifiers
Analytical instruments
Switching blocks
Control and protection units
GSM communication routers / modems
Archive
18.11.2026
Author
Based on materials from the Instrumentation and Control Service of the Bohorodchany Line Production Department of Main Gas Pipelines: V. V. Pavlyk, head of the I&C Service; Z. Y. Kotsur, I&C engineer at CS-21 Soyuz
How the I&C Service of the Bohorodchany Line Production Department upgraded the station-wide control system of compressor station CS-21 on the Soyuz gas pipeline in-house, using Microl instruments.
The station-wide automatic control systems of the compressor stations on the Soyuz main gas pipeline were supplied and installed by the German company AEG Kanis in the late 1970s. In their day they were model engineering solutions, but over more than 30 years of operation, as the equipment aged physically and became obsolete, their shortcomings came to light.
During operation of CS-21 Soyuz it turned out that the station-wide control system did not directly monitor or record a number of important parameters: gas pressure at the outlet of the fuel and starting gas treatment unit, the 110 V and 24 V supply voltages, and gas temperature at the outlet of the air coolers. There was not even an audible or visual alarm for low working gas pressure — and without working gas, the shut-off valves of the station and its gas compressor units are practically uncontrollable.

Fig. 1. UA-112 and MTR-8 microprocessor instruments in the NS-2 control panel
The new scheme improved the algorithm for switching the air cooler fans on and off and allowed the fans in both sections to be loaded evenly. The MIK-51 controllers allow quick changes to the "min" and "max" setpoints, the number of the selected fan, the fan on/off time intervals, and the differential and hysteresis of gas temperature control.

Fig. 2. MIK-51 controllers in the gas air cooler control panel
The MTR-8, MIK-51 and UA-112 instruments are connected via RS-485 and RS-232 to the engineer's PC at the main control panel, where the process parameters are displayed and archived by a purpose-built SCADA system (Fig. 3).

Fig. 3. CS-21 mimic diagram
These improvements and technical solutions by the I&C Service of the Bohorodchany Line Production Department have brought the station-wide control system of CS-21 on the Soyuz main gas pipeline up to modern standards.
For more information about the products mentioned in this article, please contact Microl LLC:
+38 (0342) 502-701
+38 (067) 359-70-90
+38 (095) 092-07-28
sale@microl.ua, microl_zbut@microl.ua, zbutmicrol@gmail.com
www.microl.ua
Technical support:
+38 (0342) 502-702
+38 (067) 704-00-29
+38 (095) 302-37-57
support@microl.ua, supmicrol@gmail.com
Prepared on the basis of materials from the I&C Service of the Bohorodchany Line Production Department (V. V. Pavlyk, Z. Y. Kotsur).
Open the booklet / download PDF